moose o death
08-01-2008, 04:36 PM
simple enough question i made a cylinder resized it using the properties page. then extruded some bits and bobs to make a piece of re-bar.
i'm going to ultimap that down to a standard cylinder, as i' originally used the properties page to get the right size instead of the scale tool can i create a duplicate cylinder using the settings from that page?
it would save some time. failing that i'll start the laborious 60 seconds to do it the "long" way. might save me some time for the next time though
i'm going to ultimap that down to a standard cylinder, as i' originally used the properties page to get the right size instead of the scale tool can i create a duplicate cylinder using the settings from that page?
it would save some time. failing that i'll start the laborious 60 seconds to do it the "long" way. might save me some time for the next time though